Download  Print this page

Troubleshooting - Kenwood kMix KMX50 series Instructions Manual

Hide thumbs
   

Advertisement

to fit and use your splashguard
1 Raise the mixer head until it locks.
2 Fit the bowl onto the base.
3 Push the splashguard onto the underside of the mixer head
until fully located. The hinged section should be positioned as shown.
4 Insert required tool.
5 Lower the mixer head.
During mixing, ingredients can be added directly to the bowl via
the hinged section of the splashguard
You do not need to remove the splashguard to change tools.
6 Remove the splashguard by raising the mixer head and sliding it
down.

troubleshooting

problem
The whisk or K-beater knocks against the bottom of
the bowl or isn't reaching the ingredients in the bottom
of the bowl.
solution
Adjust the height. Here's how:
1 With the mixer switched off, insert the beater or whisk and lower
the mixer head. Check the clearance between the tool and
the bottom of the bowl
touching the bottom of the bowl.
2 If the clearance needs to be adjusted, raise the mixer head and
remove the tool.
3 Using a suitable spanner loosen the nut sufficiently to allow
adjustment of the shaft
bottom of the bowl, turn the tool shaft anti-clockwise.
To raise the tool away from the bottom of the bowl turn
the shaft clockwise.
4 Tighten the nut.
5 Fit the tool to the mixer and lower the mixer head. Check its
position (see point 1).
6 Repeat the above steps as necessary until the tool is set
correctly. Once this is achieved tighten the nut securely.
Note:
No adjustment of the dough hook is necessary.
problem
The mixer stops during operation.
solution
If for any reason power to the mixer is interrrupted and the
machine stops working, turn the speed switch to the off position,
wait a few seconds and then re-select the speed. The mixer
should resume operating straight away.
.
. Ideally the tool should be almost
. To lower the tool closer to the
5

Hide quick links:

Advertisement

loading

  Related Manuals for Kenwood kMix KMX50 series