Kenwood HMP30 - Hand Mixer Manual

Kenwood HMP30 - Hand Mixer Manual

Also See for HMP30:

Advertisement

Kenwood HMP30 - Hand Mixer Manual

Safety

  • Read these instructions carefully and retain for future reference.
  • Remove all packaging and any labels.
  • If the plug or cord is damaged it must, for safety reasons, be replaced by
  • Kenwood or an authorised Kenwood repairer in order to avoid a hazard.
  • DO NOT process hot ingredients.
  • Do not operate your appliance for longer than the times specified below without a rest period. Processing continuously for longer periods can damage your appliance.
Function/ Attachment Maximum Operation Time Rest Period Between Operations
Beaters 6 mins Unplug the appliance and allow to cool down for 15 minutes
Kneaders
Heavy cake mixes
Bread doughs
3 mins
  • Never put the handmixer body in water or let the cord or plug get wet.
  • Keep fingers, hair, clothing and utensils away from moving parts. l Never let the cord touch hot surfaces or hang down where a child could grab it.
  • Never use a damaged handmixer. Get it checked or repaired: see 'Service and Customer Care'.
  • Never use an unauthorised attachment.
  • Always switch off the appliance and disconnect from the power supply, if it is left unattended, before assembling, disassembling or cleaning.
  • Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.
  • Misuse of your appliance can result in injury.
  • The rated power is based on the chopper attachment. Other attachments may draw less power.
  • This appliance shall not be used by children. Keep the appliance and its cord out of reach of children.
  • Children should be supervised to ensure that they do not play with the appliance.
  • Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

Cleaning

  • Always switch off, unplug and remove the beaters or kneaders before cleaning.
  • Never put the handmixer body in water or let the cord or plug get wet.
  • Never use abrasives to clean parts.

Before plugging in

  • Make sure your electricity supply is the same as the one shown on the rear of your handmixer.


Plug and Fuse Information

  • The wires in the cord are coloured as follows:
    Blue = Neutral
    Brown = Live.
  • If the plug supplied with your appliance has a fuse fitted it is rated 3A. If the fuse fails it must be replaced with one of the same rating.

Note:

  • For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).
  • If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.
  • This appliance conforms to EC Regulation 1935/2004 on materials and articles intended to come into contact with food.

Before using your handmixer for the first time

  • Wash the parts (see 'cleaning').

Key

Overview the unit

  1. Tool release button
  2. Speed selector
  3. Pulse button (P)
  4. Beaters
  5. Kneader with collar
  6. Kneader

To Use Your Handmixer

  1. Insert the beaters or kneaders – turn and push until a positive click is felt.

    check that the kneader with the metal collar is correctly fitted into the socket (refer to illustration).
  2. Plug in.
  3. With the ingredients in a bowl of an appropriate size, place the beaters/kneaders into the bowl.
  4. Select the required speed from 1 (slowest) to 5.
  • As the mixture thickens, increase the speed.
  • If the machine starts to slow or labour, increase the speed.
  • Use the pulse 'P' button to operate the motor at maximum speed.
    Note:
    the 'P' pulse button will only operate if a speed is selected first.
  1. When the mixture has reached the desired consistency, return the speed selector to the off 'O' position and then lift the beaters/kneaders out of the bowl.
  2. To remove the tools, make sure the speed selector is in the off 'O' position and unplug the handmixer. Press the tool release button 1 . Hold onto the tool shafts when ejecting the tools.

  • kneaders only - when making bread dough we recommend that the dough load does not exceed 450g flour.

Hints and Tips

  • When creaming for cake mixtures, use butter or margarine at room temperature or soften before use.
  • To avoid overloading your mixing bowl, select one of an appropriate size.
  • Large quantities and thick mixtures may require a longer mixing time.
  • When whipping cream, use of a high-sided bowl is recommended to minimise splashing.
  • Switch it off as soon as you have got the right consistency.

Please note that these are recommendations only and the speed you select may depend upon the bowl size, quantities, the ingredients you are mixing and personal preference.
Gradually increase to the recommended speeds below.

Food type
(Mins)
Beaters
Egg whites 1 - 10 4 – 5 1 - 3
Whipping Cream (Processing times may vary, depending on fat content of cream) 200 - 500 ml 1 – 5 2 - 3
All-in-one cake mixes 1kg Total weight 1 – 5 1 – 2
Batter 1 litre 5 1

Rubbing fat into flour

Adding water to combine pastry ingredients

250g Flour weight

1 – 2

2

4

1

Fruit cake

Creaming fat and sugar

Folding in flour, fruit, etc.

900g Total weight

5

1 – 2

3 - 4

1

Kneaders
Bread

450g Flour weight

750g Total weight

4 – 5 2 – 3

Optional attachment (not supplied in pack)

Mini chopper - refer to 'Service and Customer Care" section to order.

Service and Customer Care

UK
If you need help with:

  • using your handmixer or
  • servicing or repairs (in or out of guarantee)
    call Kenwood customer care on 0345 222 0458 or visit www.kenwoodworld.com.
    Have your model number(e.g. TYPE HMP30) and date code (5 digit code e.g. 19C11) ready.
    They are located on the rear of the power unit.
  • spares and attachments
    call 0844 557 3653.

Other countries

  • If you experience any problems with the operation of your appliance, before requesting assistance refer to the'Troubleshooting Guide' section in the manual or visit www.kenwoodworld.com.
  • Please note that your product is covered by a warranty, which complies with all legal provisions concerning any existing warranty and consumer rights in the country where the product was purchased.
  • If your Kenwood product malfunctions or you find any defects, please send it or bring it to an authorised KENWOOD Service Centre. To find up to date details of your nearest authorised
  • KENWOOD Service centre visit www.kenwoodworld.com or the website specific to your Country.
  • Designed and engineered by Kenwood in the UK.
  • Made in China.



FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH THE EUROPEAN DIRECTIVE ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE)

At the end of its working life, the product must not be disposed of as urban waste.
It must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service.

Guarantee (UK only)
If your handmixer goes wrong within one year from the date you bought it, we will repair or replace it free of charge provided:

  • you have not misused, neglected or damaged it;
  • it has not been modified (unless by Kenwood);
  • it is not second-hand;
  • it has not been used commercially;
  • you have not fitted a plug incorrectly; and
  • you supply your receipt to show when you bought it.

This guarantee does not affect your statutory rights.

Recipe

White bread dough
10ml/2 tsp dried yeast (the type that requires reconstituting)
5ml/1 tsp sugar
250ml warm water
450g bread flour
5ml/1 tsp salt
15g lard

  1. Place the dried yeast, with the sugar and water, in a mixing bowl and leave to froth. The correct water temperature should be 43°C and can be achieved by mixing one third boiling water with two thirds cold water.
  2. Add the remaining ingredients. Fit the kneaders to the handmixer, then combine the ingredients together on a low speed until the flour is incorporated. Then increase the speed and knead for approximately 2-3 minutes, until the dough is smooth and elastic. Cover with oiled cling film and leave the dough to rise in a warm place for 45-60 minutes.
  3. Re-knead the dough on maximum speed for 30-45 seconds, keeping the kneaders in the mix.
  4. Shape the dough into a loaf, or rolls, and place on greased baking trays. Cover with oiled cling film and leave somewhere warm until it has doubled in size.
  5. Bake in a preheated oven at 230°C/450°F/Gas mark 8 for 20-25 minutes (for a loaf) or 10-15 minutes (for rolls). When ready, the dough should sound hollow when tapped on the base.

Troubleshooting Guide

Problem Cause Solution
Handmixer does not operate. No power. Check appliance is plugged in.
Kneader with collar cannot be inserted into socket. Fitting kneader to wrong socket The kneader with the collar will only fit into the socket.
Handmixer starts to slow or labour during processing.

Speed selected too low.

Recommended quantity exceeded.

Increase speed.
Refer to Recommended Usage Chart for speeds and quantities to process. Do not operate for longer than 3 minutes without a 15 minute rest period with doughs or heavy cake mixes.
Excessive splashing or flour spray during processing.

Speed selected too high.

Bowl too shallow or too small for ingredients being processed.

Select a lower speed initially and increase as the mixture thickens.

Select an appropriate sized mixing bowl.

Unable to remove tools from sockets. Speed selector not in 'O' position. To remove the tools, make sure the speed selector is in the OFF "O" position and unplug the handmixer. Press the tool release button.
Pulse button does not operate Speed not selected first. The Pulse function will only operate if a speed has been selected first. Select a speed and then press the 'P' pulse button.

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Kenwood HMP30 - Hand Mixer Manual

Advertisement

Need Assistance?

Do you have a question about the HMP30 that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents