Preparations For Initial Start-Up - Westerbeke 44A FOUR-35 C THREE Operator's Manual

PREPARATIONS FOR INITIAL START-UP
PREST ART INSPECTION
Before starting your engine for the first time or after a pro-
longed layoff, check the following items:
D
Check the engine oil level. Add oil to maintain the level
PLASTIC RECOVERY TANK
at the high mark on the dipstick.
D
Turn on the fuel supply, then check the fuel supply and
examine the fuel filter/water separator bowl for contami- CAP
nants.
D
Check the transmission fluid level.
NOTE:
Refer to the previous page for
fue~
oil and
transmission fluid.
D
Check the DC electrical system. Inspect wire connections .
and battery cable connections. Make certain the positive
( +) battery cable is connected to the starter solenoid and
the negative (-) cable is connected to the engine ground
:.'\Il>'~~
stud (this location is tagged).
D
Check the coolant level in both the plastic recovery tank
and at the manifold.
NOTE:
If
the engine has not yet been filled with coolant,
refer to the COOLING SYSTEM section of this manual.
D
Visually examine the engine. Look for loose or missing
parts, disconnected wires, and unattached hoses. Check
the threaded connections and engine attachments.
D
Make certain there is proper ventilation around the
engine. An ample supply is necessary for proper engine
performance.
D
Make sure the mounting installation is secure.
D
Ensure the propeller shaft is securely attached to the
transmission.
D
Open the through-hull and prime the raw water intake
strainer. Inspect the raw water supply.
Engines & Generators
8
OIL FILL CAP