Direct Playback; Adjusting The Brightness Of The Display - Pioneer VSX-909RDS Operating Instructions Manual

Direct Playback

This mode is for playing back a sound source in its purest form, no tone adjustments or other sound modes can
be used.
Î
USE SETUP
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TVCONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
7 3 8
¶
DIGITAL
– SIGNAL
NR SELECT
MULTI CH STEREO/
MIDNIGHT DSP
INPUT
DIRECT
/DTS/MPEG
LIGHT THX ADVANCED STANDARD
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
STEREO/
DIRECT

Adjusting the Brightness of the Display

Use the FL DIMMER button to adjust the brightness of the fluorescent display (FL=fluorescent display).
FL DIMMER
1 Put the remote control slide switch in USE.
2 Use the STEREO/DIRECT button to alternate
1
between STEREO or DIRECT mode (you can
also use the STEREO/DIRECT button on the
front panel).
The DIRECT mode will give you the most accurate reproduction of
two channel (stereo) sources but won't let you add any effects to
2
the sound.
• None of the tone controls or other sound modes can be
memo
used with DIRECT playback.
• If the receiver is in a different mode than STEREO to start
with the first push of the STEREO button will put it in STE-
REO mode. After that the button will toggle the receiver
between STEREO and DIRECT mode.
• For more on this button see the explanation of STEREO
mode on p.44, 45, 47.
Press the FL DIMMER button.
Four levels of brightness ranging from very dim to very bright can
be selected. Each press changes the brightness of the display.
When rotating through the options, the default brightness can also
be selected.
Please note: it is a feature of this unit that the fluorescent
memo
display will be brighter for a few seconds after you choose a
function (like DVD/LD, CD, etc.) and then get softer. This will
still happen when you adjust the brightness but the new set-
ting will be the one the display softens to.
SIGNAL STEREO
SELECT
A
ANALOG SP
Basic Playback
VOLUME
dB
53
En