Direct Playback; Adjusting The Brightness Of The Display - Pioneer Elite VSX-39TX Operating Instructions Manual

Direct Playback

STEREO
Receiver
DSP STEREO
/ dts
ADVANCED
THX
STANDARD
THEATER
MIDNIGHT
DIGITAL
LOUDNESS
NR
STEREO/DIRECT

Adjusting the Brightness of the Display

Use the FL DIMMER button to adjust the brightness of the fluorescent display (FL=fluorescent display).
FL DIMMER
Receiver
TAPE 2
FL
MONITOR
DIMMER
BASS
INPUT SPEAKER
ATT.
A/B
TONE
CH
LEVEL
FL DIMMER
MAIN
MAIN SUB
EFFECT
MULTI CH
IN
SIGNAL
SELECT
SUB
MAIN SUB
TREBLE
CH
SELECT
SYSTEM
SETUP
Use the STEREO button on the
remote control or the STEREO/
DIRECT button on the front panel to
alternate between STEREO and
DIRECT mode.
The DIRECT mode will give you the most accurate
reproduction of two channel (stereo) sources but
won't let you add any effects to the sound.
SIGNAL STEREO
SELECT
ANALOG SP A
• None of the tone controls or other sound modes
memo
can be used with DIRECT playback.
• If the receiver is in a different mode than
STEREO to start with the first push of the
STEREO button will put it in STEREO mode.
After that the button will toggle the receiver be-
tween STEREO and DIRECT mode.
• Relatedly, see the explanation of the TONE but-
ton on p.22 and the STEREO mode on p.45.
Use the FL DIMMER button on the
remote control or the front panel to
alternate between the different
levels of brightness.
Four levels of brightness ranging from very dim to
very bright can be selected. Each press changes the
brightness of the display. When cycling through the
options, the default brightness can also be selected.
Please note: It is a feature of this unit that the
memo
fluorescent display will be brighter for a few sec-
onds after you choose a function (like DVD/LD,
CD, etc.) and then get softer. This will still happen
when you adjust the brightness but the new set-
ting will be the one the display softens to.
Basic Playback
VOLUME
dB
53