Using The System Off Button; Setting Up The Direct Function - Pioneer VSX-909RDS Operating Instructions Manual

Using the System Off Button

This button will turn off the receiver and any component that has programmed into the SYSTEM OFF settings
(see above) as well as turn off all PIONEER components regardless of whether they have been programmed
into SYSTEM OFF. If you use this feature when a DVD is playing, the player will stop the play mode before
switching off.
Î
USE SETUP
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TVCONT
TAPE1

Setting Up the Direct Function

The DIRECT FUNCTION is designed in case you have an external video source connected to your TV (a video
source that is not going through the receiver). For this explanation we'll call this the "external video deck." You'd
like to control the external video deck with this unit's remote control so you've assigned it a function button (for
example purposes, the VCR 2 button). Yet, if you put the receiver in VCR 2 mode you'll get no picture on your
TV because the external video deck signal is not going through the receiver. To get around this problem you set
the DIRECT FUNCTION for VCR 2 to OFF. Now when you press VCR 2 function button you can control the
external video deck with the remote but the receiver does not go into VCR 2 mode.
Î
USE
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TVCONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
¶ 7 3 8
- + - +
TUNING STATION
1 ¡ 4 ¢
-
+
CHANNEL
4
1 2 3
2
4 5 6
7 8 9
0
+10
DISC
RF ATT DISPLAY
+ +
TV
TV VOL TV CONTROL VOLUME
– –
TV FUNC
REMOTE SETUP
2,5
INPUT
MENU MUTE
ATT
SYSTEM SETUP
EFFECT/ +
FUNCTION
CH SEL
ENTER
DIGITAL – SIGNAL
NR
SELECT
MULTI CH
STEREO/
MIDNIGHT DSP
INPUT DIRECT
/DTS/MPEG
LIGHT THX ADVANCED STANDARD
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
1 Set the remote control slide switch to USE.
1
2 Press the SYSTEM OFF button on the
2
remote control.
1 Set the remote control slide switch to
1
SETUP
SETUP.
3
Also make sure that your TV is on and set to the receiver.
2 Press the REMOTE SETUP (INPUT ATT)
button and
the DIRECT FUNCTION mode.
The MULTI CONTROL buttons DVD/LD, TV/SAT, VCR 1, VCR 2,
CD, and MD/TAPE 1 start to blink.
Direct Function
You can choose whether
the commander sends a
function code or not ,
when you press each
Multi-control button.
1Select function.
2Input YES or NO.
EXIT = Remote Setup
3 Select a component by pressing its MULTI
CONTROL button.
4 Set the DIRECT FUNCTION of each external
source to NO by pressing
5 Press the REMOTE SETUP button to exit the
DIRECT FUNCTION mode.
• When you're done setting up, remember to set the slide
switch back to USE.
memo
at the same time to select
4
YES =1
TRANSMIT
NO =2
The default setting is all YES. If you have turned a DIRECT
FUNCTION to NO and want to turn it back to YES, follow
the directions above and press
Using Other Functions
.
2
in step 3.
1
81
En