Performing Multi Operations - Pioneer VSX-909RDS Operating Instructions Manual

Î
USE SETUP
S0URCE RECEIVER
6- 2
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TVCONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
¶ 7 3 8
6- 3
- + - +
TUNING STATION
1 ¡ 4 ¢
-
+
CHANNEL
1 2 3
4 5 6
7 8 9
0
+10
DISC
RF ATT DISPLAY
+ +
5
TV
TV VOL TV CONTROL VOLUME
– –
TV FUNC
REMOTE SETUP
7
INPUT
MENU MUTE
ATT
SYSTEM SETUP
EFFECT/ +
FUNCTION
CH SEL
ENTER
DIGITAL SIGNAL
–
NR
SELECT
MULTI CH
STEREO/
MIDNIGHT DSP
INPUT DIRECT
/DTS/MPEG
LIGHT THX ADVANCED STANDARD
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT

Performing Multi Operations

Once you've programmed a Multi Operation, here's how to use it.
Î
USE SETUP
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TVCONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
¶ 7 3 8
- + -
+
TUNING STATION
1 ¡ 4 ¢
- +
CHANNEL
1 2 3
4 5 6
7 8 9
5 Press the operation button, for example TV
(POWER), you want to input.
6 Repeat steps 4 and 5 to input MULTI
6- 1
OPERATIONs to the MULTI CONTROL
button you pressed in step 3. You can also
tell the receiver to go into a specific sound
mode (THX, ADVANCED, STANDARD,
MULTI CH IN, MIDNIGHT, DSP, DNR or
STEREO) by inputting that command (for
example, see operation 4 below).
You can repeat this process for up to five commands.
For example : you could enter the following four operations using
the preceeding steps 4 and 5.
1 Press the TV CONTROL button and TV
6- 4
your TV (as explained above).
2 Press the DVD/LD button then
DVD player (if it is not a PIONEER product).
3 Press the DVD/LD button then 3 (play) to start playing the
DVD player.
4 Press the ADVANCED button to put the receiver in that sound
mode.
When you employ MULTI OPERATIONs (see below), these four
tasks will be performed in the same order.
7 Press the REMOTE SETUP button to exit the
Multi-operation setup mode.
The remote control and TV return to their previous operation
modes.
1
1 Set the remote control slide switch to USE.
2
2 Press the MULTI OPERATION button on the
3
remote control.
The MULTI CONTROL buttons start to blink.
3 Press the MULTI CONTROL button to
activate that Multi Operation.
The remote sends the Multi Operation commands you pro-
grammed.
Using Other Functions
(POWER) to turn on
(POWER) to turn on your
79
En