Maintenance Maintenance - MK Diamond Products MK-20 SERIES Owner's Manual

MK-20 SERIES
(A)
Verify the engine is off and cool be-
fore beginning to clean. Clean the
saw with soap and water.
MAINTENANCE SCHEDULE
Item should be performed at every indicated hour(s) or interval period whichever goes first.
Maintenance Schedule
Air Filter
Hydrostatic
Transmission/Reservoir
Mainframe
Battery
Engine
(B)
Clean water system outlets,
including water tubes in blade
guard.
Maintenance
Operation
Check
Change Air Filter
Check Oil
Blade Shaft
Bearings
Pivot Bearings
Chain Drive
Transmission
Control Assemblies
Battery
V-Belts
Check Water Level
Definitive information on engine maintenance is contained in the Engine Manual
provided separately. Perform all maintenance procedures as recommended by the
engine manual.
Clean the remainder of the exterior
Daily
Every 4 Hours
When Dry Cutting
Every 8 Hours
When Wet Cutting
•
Lube Blade Shaft
Bearings at end of
Operations
•
24
MAINTENANCE
(C)
surface (except the engine).
25 Hours 100 Hours or
or Weekly Seasonal
•
Adjust Tension
•
•
Replace
•
•
•
•
•