MK Diamond Products MK-20 SERIES Owner's Manual page 22

MK-20 SERIES
BLADE GUARD REPOSITIONING
WARNING
(A)
Remove Diamond Blade.
(D)
Remove the Blade Guard
Retaining Bolts and remove the
Blade Guard.
(G)
Install the Blade Guard on the
opposite side of the saw.
Do not operate saw with any guards removed. Turn master engine switch to off
position to avoid accidental starts when removing guards.
Remove the Cooling Transfer
Hose from the Blade Guard by
pressing the quick release.
Locate the Blade Shaft Cover
Install Diamond Blade
.
(B)
(E)
Retaining Bolts.
(H)
22
OPERATION
(C)
Locate the four Blade Guard Re-
taining Bolts.
(F)
Remove the Blade Shaft Cover
Retaining Bolts and the Blade
Shaft Cover.
(I)
Install the Cooling Transfer Hose
to the Blade Guard.