Table of Contents
Advertisement
MK-20 SERIES
TRANSPORT
CAUTION 1. The MK-20 Series weighs approximately two hundred and thirty-five (235
2. Two people are required to lift and transport the MK-20 Series.
DESCRIPTION OF CONTROLS
2
3
5
4
1.
The Depth Control Wheel raises the blade when rotated clockwise, and lowers the blade
when rotated counterclockwise.
2.
The keyed ignition switch turns clockwise to the on and start positions. The engine turns
over with the switch in the start position. Release the key after the engine starts.
3.
When the engine is running, the Tach/Hour Meter display will indicate the engines RPM.
When the engine is shut off, the display will switch to run time, initially in minutes, and
then switching to hours after the first hour of operation.
4.
The Transmission Speed Lever moves the saw forward by pushing the lever away from
the operator and moves the saw in reverse by pulling the lever toward the operator.
Always place this control in central neutral position before using the engage/disengage
lever or starting or stopping the engine.
5.
The Throttle control increases engine rpm from slow (idle) at the bottom, to fast
(full rpm) at the top.
6.
Depth Gauge should be adjusted to zero when setting up the saw.
7.
Use water hose bibb for wetting cutting. After connecting hose, turn on the water at the
source and use Water Control Lever to control flow of water to the blade. Be sure that
both sides of the blade are getting adequate flow of water.
8.
Water Control Lever is off in the vertical position and fully on in the horizontal position. It
may be placed at in between settings to regulate the water flow.
9.
The Transmission Engage/Disengage Lever is engaged in the full down position.
10. The Choke is located on the back panel for convenient cold starting.
pounds), use care when transporting.
1
6
7
12
TRANSPORT
9
10
8
Advertisement
Table of Contents
