Installation Step - GE Monogram ZEW145 Use And Care & Installation Manual

7
Installation
Step
(continued)
Jo~n@
multiple
cooktops
Remove —
These Nuts
Cooktop
Joiner Strip
H
D/agram57
7
If available, an assisrant can ease the installation process. " Place flanged nuts in end of 5/16" nutdriver. From
" Using a large, solid work surface, lay cooktops upside
under counter, start nuts on studs and tighten.
down on soft, clean towel.
. Remove endcaps on sides to be joined by removing
three nuts with 5/ 16" nutdriver. Discard nuts.
. Attach joiner strip to first cooktop using nuts with
flanges and tighten.
- Place the two cooktops in countertop cutout.
- Slide the two cooktops together so that the slots in the
joiner strip are engaged by the studs, and no gaps are
between cooktops and joiners.
Note: Firmly
press two cooktops
together against joiner strip to
assure tight fit.
Attachin~ When attaching gas to gas, gas to Halogen, Halogen to
chassiss;'oti
Halogen, or grill to grill, place support brace as shown.
braceto
One brace supplied with each component.
. Remove one screw from center of each cooktop chassis.
equal-height
-
Position brace and retighten screws.
cookt@s
(Repeat above steps for three cooktops.)
gram 512
Attaching
When attaching grill to Halogen/Radiant or gas, place
chassissu~ort
support brace as shown.
braceto
.
Remove one screw from center of each cooktop chassis.
d~jment-height
.
Position brace and retighten screws.
cookto@
(Repeat above steps for three cooktops.)
hagrarn573
51