Installation Instructions; Before You Begin - GE Profile PP9830 Owner's Manual

Installation
Instructions
If you have questions, call 800.GE.CARES or visit our website at: GEAppliances.com.
WARNING
switch power off at the service panel and lock the
service disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag,
to the service panel.
WARNING
To reduce the risk of fire, use only
metal ductwork.

BEFORE YOU BEGIN

Read these instructions completely and
carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
codes and ordinances.
IMPORTANT –
•
and material and literature before connecting gas
and electrical supply to cooktop.
IMPORTANT –
•
your cabinets, check with your builder or cabinet
supplier to make sure that the materials used will
not discolor, delaminate or sustain other damage.
This product has been designed in accordance
and complies with the maximum allowable wood
cabinet temperatures of 194°F (90°C).
• Note to Installer –
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Servicer – The electrical diagram is located inside
the cooktop.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
14
Radiant Downdraft Cooktop
PP9830
Save these
Observe all governing
Remove all packing
To avoid damage to
TOOLS YOU WILL NEED
• Safety Glasses
• Saw
• Pencil
• Measuring tape
or scale
• Carpenter's square
• Electrician's Pliers
MATERIALS YOU MAY NEED
• Sheet metal screws
• Junction box
• Strain relief clamp for 1/2" trade size conduit
• Wire nuts
CUTTING THE COUNTERTOP
If you are installing the cooktop in a solid surface
material such as granite, quartz or any other natural
or synthetic solid surface, we recommend that the
cutout be prepared by a professional cabinet or
coutertop installer.
Cooktop cutouts in wood or wood -laminate
countertops may be able to be prepared using a
saber saw and electric drill.
• Adjustable wrench
or socket set ( 7 / "
16
socket and ratchet)
•
• 1 / " nut driver
4
• Flat blade screwdriver
49-2001160 Rev. 0