Output Terminal Panel Familiarization - MULTIQUIP Power WHISPERWATT DCA-56SPX Operation And Parts Manual

DCA-56SPX — OUTPUT TERMINAL PANEL FAMILIARIZATION
Connecting Loads
Loads can be connected to the generator by the Ouput
Terminal Lugs or the convenience receptacles (Figure 13).
Make sure to read the operation manual before attempting
to connect a load to the generator.
To protect the output terminals from overload, a
3-pole, 250A main circuit breaker is provided. Make sure to
switch ALL circuit breakers to the OFF position prior to
starting the engine.
Figure 13. Connecting Loads
PAGE 28 — DCA-56SPX— OPERATION AND PARTS MANUAL — REV. #1 (04/22/10)
Over Current Relay
An over current relay (Figure 14) is connected to the main
circuit breaker. In the event of an overload, both the circuit
breaker and the over current relay may trip. If the circuit
breaker can not be reset, the reset button on the over cur-
rent relay must be pressed. The over current relay is lo-
cated in the control box.
Figure 14. Over Current Relay