MULTIQUIP Power WHISPERWATT DCA-220SSJ Operation And Parts Manual page 32

Setup 4-Up Display
1. From the single or four engine parameter display touch
the "Menu Button".
0 1500 3000
1800 RPM
ENG RPM
COOL TEMP
2. The main menu will pop up on the display. Use the "Arrow
Buttons" to scroll through the menu until the "Setup 4-
Up Display" is highlighted.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONFG
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
3. Once the "Setup 4-Up Display" menu item has been
highlighted touch the "Enter Button" to activate the
"Setup 4- Up Display" menu.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONFG
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
4. Touch the "Enter Button" to activate the "Use Defaults"
function. This action will reset the unit to the factory
default.
USE DEFAULTS
CUSTOM SETUP
PAGE 32 — DCA-220SSJ— OPERATION AND PARTS MANUAL — REV. #1 (03/22/07)
DCA-220SSJ — DIAGNOSTIC DISPLAY
5. The "Use Defaults" screen will be displayed during the
1000 RPM
98%
LOAD RPM ENG RPM
14.2 57 PSI
BATT VOLT
OIL PRES
6. Select the "4-Up Custom Setup" from the "4-Up Setup"
7. The quadrant with the backlit parameter value is the current
8. Touch the "Enter Button" and a list of parameters will appear.
resetting period then will automatically return to the
"Setup 4- Up Display" menu.
RESTORED TO
DEFAULTS
menu.
USE DEFAULTS
CUSTOM SETUP
selected parameter. Use the "Arrow Buttons" to highlight
the parameter value in the quadrant you wish to place a
new parameter.
USE DEFAULTS
CUSTOM SETUP
125°F
COOL TEMP
14.2
BATT VOLT
1000 RPM
ENG RPM
57 PSI
OIL PRES