Inserting Alignment Pin; Installing Carburetor Assembly With Linkages; Securing Ground Lead; Connecting Fuel Line To Carburetor - Kohler Courage SV470 Service Manual

Section 10
Reassembly
4. Models with one screw and one mounting stud
only: Insert a 3/16" diameter rod, approximately
4" long, into the open mounting hole in the heat
deflector to serve as a temporary alignment pin.
See Figure 10-59. Be careful not to force the rod or
damage the threads.
Temporary Alignment Pin
Figure 10-59. Inserting Alignment Pin.
5. Install a new carburetor gasket onto the
mounting stud(s) and/or alignment pin.
6. Attach the choke and throttle linkages to the
carburetor and install the carburetor assembly.
See Figure 10-60. If the governor lever was not
disconnected, slide it onto the governor shaft
with the lever up.
Figure 10-60. Installing Carburetor Assembly with
Linkages.
10.18
Throttle Linkage
Choke Linkage
7. If the carburetor has a fuel solenoid, fasten the
ground lead to the crankcase boss, with the
toothed washer between the eyelet terminal and
the boss. See Figure 10-61. Torque the screw to
8.0 N·m (70 in. lb.). Connect the solenoid power
lead to the wiring harness and secure with a tie
strap. See Figure 10-62.
Ground Lead
Figure 10-61. Securing Ground Lead.
Figure 10-62. Fuel Solenoid Lead Secured with Tie
Strap.
8. Connect the fuel line to the carburetor and secure
with a hose clamp. See Figure 10-63.
Figure 10-63. Connecting Fuel Line to Carburetor.