Table of Contents
Advertisement
Installation
dimensions
Product
clearances
10
The wine chiller can be a free-standing
model or can be built in using the cut-out
dimensions below.
603 mm
876 mm
NOTE:
Handle and handle standoff
depth is 45 mm
The wine chiller is factory set for a 110°
door swing.
When installed in a corner:
• Allow 100 mm minimum clearance on
the hinge side for the 90° door swing
and to allow racks to slide out.
• Allow 360 mm minimum clearance on
the hinge side for a full 110° door swing.
• The door swing is reversible on all models.
If desired, change the door swing before
installation.
Choose the location:
• These products may be closed in on the
top and three sides as long as the front
is unobstructed for air circulation and
proper access to the door.
• Do not install these products where the
temperature will go below 55°F (13°C)
or above 90°F (32°C).
• Do not install where it will be subject to
direct sunlight, heat or moisture.
Built-In Dimensions
When building in the wine chiller, be sure
to allow for a full door swing so you have
full access to the pull-out drawers.
See the Installation Instructions for
complete directions.
603 mm
Cut-out dimensions:
Height: 875–890 mm
Width: 603 mm minimum
Depth: 610 mm minimum
Black or Stainless Steel Toekick Options
These products are shipped with a black
toekick installed. An optional stainless steel
toekick is also supplied with each product.
For shipping purposes, the stainless steel
toekick is secured to the back of the unit.
Wine Chiller
360 mm Min.
to Wall
110°
90° Door Swing
530 mm
600 mm
90°
100 mm Min.
to Wall
Advertisement
Table of Contents
