Before you begin—Read these instructions completely and carefully. IMPORTANT: Save these instructions for local inspector’s use. IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTE TO INSTALLER: Be sure to leave these instructions with the Consumer. NOTE TO CONSUMER: Keep these instructions with your Owner’s Manual for future refer- ence.
ZDB24 WW Models White Beverage Center Available ZDB24 BB Black Beverage Center ZDW24 WW White Wine Chiller ZDW24 BB Black Wine Chiller Front ventilation allows the beverage center Dimensions or wine chillder to be installed as a built-in & Clearances and still operate efficiently.
IMPORTANT - (Please read carefully) Grounding FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED. Beverage Center or Wine Chiller The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (grounding) wall receptacle to minimize the possibility of electric shock hazard from this...
To remove the door: Reverse • Remove the top hinge pin using a 1/8" Allen Door wrench. Set aside. • Lift the door off the bottom hinge. Swing • Remove the top hinge and set aside. • Remove the bottom hinge, the plastic washer and the bottom hinge pin using a Phillips screwdriver.
D. 3 Set screws (2 required, 1 extra) E. 3/32" Allen wrench for set screws F. 4 U-Clips G. 4 Leveling legs H. GE Monogram nameplate I. 8 Plug buttons J. Hinge Shims K. 2 Screws for light trigger hole CAUTION: Small objects are a choke hazard to children.
• Tilt the unit slightly to one side to access the bottom corner holes. Step • Install a U-Clip into the front and rear holes on the bottom as shown. Install CAUTION: See illustration. Be sure the tangs on the clips are on the outside and the Leveling straight portion is inserted into the holes.
Template For Nameplate Location To be used when door swing has been reversed, with handle on right side, hinge on left side. To position new nameplate: • Remove the original nameplate, now located on the bottom of the door. • Cut template along dotted line. •...
Need help?
Do you have a question about the Monogram ZDB24 BB and is the answer not in the manual?
Questions and answers