Built-In Dimensions; Installation Dimensions - GE Monogram ZDWC240 Owner's Manual

Built-In Dimensions
I,l ine (killer
Installation
dimensions
Tile wine chiller can be a free-standing
model or can be buih in using tile cut-out
dimensions below.
X4'hen building in the wine chiller, be sure
to allow tbr a fllll door swing so you haxe
fllll access to tile pull-out drawers.
See tile Installation Instructions (Pub. No.
49-60910) for complete directions.
233/4' ' 233/4' '
(603 mm) w -,,=c (603 ram)
341/2"
(876 mm)
Product dimensions:
Height: 34/2 (876 ram)
Width: 2, "/4 (603ram)
Depth: 23!%" (603 ram)
Note:
Handle and
handle standoff
1%"
depth is
Cut-out dimensions:
34/2-3a (876-889 ram)
Height: 1 _"
Width: 94" (610 ram) minimum
Depth: 94" (610 ram) minimum
The wine chiller is factoiv set for a l l 0 °
door swing.
When installed in a corner:
• Allow 4" minimum clearance on the
hinge side for tile 90 ° door swing and
to allow racks to slide out.
t!
Allow l0 minimum clearance on the
hinge side %r a fllll l l 0 ° door swing.
Tile door swing is rmersible on all models.
If desired, change tile door swing before
installation.
Choose the location:
These products may be closed in on the
top and three sides as long as the fiont
is unobstructed tbr air circulation and
ixoper access to tile door.
Do not install these products where the
(l_ c)
temperature will go below 55°F 3° •
or aboxe 90°F (, 2 C)
Do
not
install where it will be
subject to
direct sunlight, heat or naoisture.
",,
'N
110° .
10"Minimum
to Wall
90° DoorSwing
l '
2 0-7/8"
i
L
_,,
1 23-5/8"
90°
........... _[ ,,,_
4" Minimum
to Wall
Black or Stainless Steel Toekick Options
These products are shii)ped with a black
toekick installed. An optional stainless steel
toekick is also supplied with each product.
For shii)ping i)uiposes, the stainless steel
mekick is secured m tile back of tile unit.
12