Primera Bravo II Calibration Instructions page 3

E. Adjust Picking left to Right
If the CD is getting pushed to the left or right when the arm is attempting to pick for any one
location, adjust with the following instructions:
Adjust the pick position left and right for the respective location by changing the values (with
numbers in increments no larger than 2 at each adjustment attempt - i.e. try these values
progressively - 00, 02, 04, 06, etc...) in the respective field. Keep in mind that using a negative
value (i.e. -02, -04, -06) will move the arm position to the right, and positive values to the left.
Click the Move button next to the proper location to move the arm over that position. Click Pick
to test it.
F. Adjusting Picking Front to Back – (Printer Tray and Burner Tray only)
Printer Tray - Forward and backward adjustments are made with the Tray Out Position. The
higher the positive value closer to +32 the further out the tray will come when ejected. Opposite
goes for negative values entered. The tray will not eject as far. This would help if the arm is
pushing the disc forward or backward to try to center the fingers in the hub of the disc.
CD/DVD Burner Tray – You need to physically adjust the drive position forward or backward, so
the arm can pick correctly out of the drive. Loosening four screws holding the drive in place
inside the Bravo allows the drive to move.
You will NOT need to remove the cover to access the screws. There are four total that will free
up the drive to adjust it forward and backwards. Open the lid and look down at the metal plate
just below the drive, you will see two screws that are torx heads. You will also notice that they
are in slots and not holes. These slots are what the drive will slide in to get your micro