Download Print this page

GE GXCF25FBS Chiller Owner's Manual: Important Safety Information; Safety Precautions; Proper Installation And Location

Ge tri-temperature water dispenser owner's manual.
Hide thumbs



Use this appliance only for its intended purpose as described in this Owner's Manual.
When using electrical appliances, basic safety precautions should be followed, including the following:
This water dispenser must be properly installed
and located in accordance with these instructions
before it is used.
Do not allow children to climb, stand or hang
on the outside of the dispenser, or on the shelves
inside the storage cabinet (on some models).
They could tip the dispenser over and damage
it and seriously injure themselves.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
Unplug the water dispenser before cleaning
or making repairs.
NOTE: GE does not support any servicing of the
dispenser. We strongly recommend that you do not
attempt to service the dispenser yourself.
Do not use this dispenser to dispense anything
other than water.
Do not plug in the power cord or turn on the power
switches when the water dispenser is empty.
Allow at least 1" (2.5 cm) of space between the
back of the water dispenser and the wall to allow
for proper air circulation.
Do not install the water dispenser where
the temperature will go below 50°F (10°C) or
above 100°F (38°C).
Wipe up any water spills immediately after loading
or unloading water bottles.
Children should be supervised by a parent when
using this product.
Do not use with water that
is microbiologically unsafe or of unknown quality.
The dispenser heats water
to a temperature of approximately 194°F (90°C).
Water temperatures above 125°F (52°C) can cause
severe burns or death from scalding. Children,
the disabled and the elderly are at highest risk
of being scalded.
This product is intended solely
for use in chilling canned and boxed beverages,
and packaged nonperishables.
Install the water dispenser on a level floor strong
enough to support it when fully loaded. Do not
install where it will be subject to direct sunlight,
heat or moisture.
Stainless steel panels (on some models) are covered
with protective film. Remove the film before
operating the product.


   Also See for GE GXCF25FBS Chiller

   Related Manuals for GE GXCF25FBS Chiller

Comments to this Manuals

Symbols: 0
Latest comments:
  • Craig Jun 01, 2017 03:33:
    Isn't there a screw on the back somewhere that you can turn left or right to change the temperatur​e of the cold side?
  • Linda Aug 01, 2014 02:11:
    For some reason my cooler won't work the light don't come on so it won't high or cold water please help!!!