Power Connections And Initialization; Ac Power Connections - Siemens SIMATIC TI500 User Manual

Power Connections
and Initialization
TIWAY I Gateway User Manual
After mounting the unit in an appropriate location, follow these steps for
connecting the power supply and running diagnostic tests.
1. Remove the shield covering the three AC terminals (Line, Ground, and
Neutral).
2. With power off, attach all three connections according to Figure 3-2 and
then replace the shield.
AC Power
Connections
Figure 3-2 AC Power Connections
3. Apply power to the unit.
4. Install loopback connector on each RS-232 port.
5. Set the Online/Offline switch on the Gateway to the OFFLINE position.
Gateway Installation and Configuration
I00xxxx
3-3