Weber SP 200 LP Owner's Manual page 30

d) Unlatch the Spider Stopper Guards and remove.
Figure 12.
Figure 13
e) Remove the manifold bracket and unscrew the two
thumb screws that hold the manifold to the cooking
box. Pull the manifold and valve assembly out of the
burners and carefully set it down. Figure 13.
Figure 14
f) Slide the burner assembly out from under the guide
screw and washer in the corners of the cooking box.
Figure 14.
Guide screw
Figure 15
View from behind
cooking box
Thumb screws
g) Lift and twist the burner assembly slightly, to
separate the crossover tube from the burners.
Figure 15. Remove the burners from the cooking
box.
Crossover tube
h) To reinstall burners, reverse steps c) through g).
i) Reinstall the Spider Stopper Guards. Slightly rotate
the Spider Stopper Guards so that the seams are in
line with the Venturi fins. There should be no gaps
in the seams or in the fit around the burners and
valves. Figure 16.
Venturi fin
Check fit around burner
CAUTION: If the Spider Stopper Guards do not fit
tightly, contact Weber-Stephen Customer Service.
CAUTION: After reinstalling the gas lines, they
should be leak checked with a soap and water
solution before using the barbecue. (See Step
"Check for gas leaks".)
30
Figure 16
Check fit around
valve
Figure 17