Weber SP 200 LP Owner's Manual page 13

Step 8
Install manifold bracket
You will need: manifold bracket
Hook the bracket onto the manifold at the center burner
valve. Figure 9. Place your hand underneath the
bracket. Lift the bracket, manifold and cooking box
slightly as a unit and hook onto the frame brace.
Figure 9
Manifold bracket
Frame brace
Step 9
Install tank panel assembly
You will need: tank panel assembly, 1 1/4 inch bolt,
1/4-20 hex nut, 1/4 inch nylon washer and a 7/16 inch
wrench.
Insert the tank panel tabs into the slots in the frame
brace. Slide up until the notch at the bottom of the tank
panel fits over the cross brace. Figure 10 (a).
Add the washer to the bolt. Put the bolt through panel
and frame brace, add hex nut and tighten with the 7/16
inch wrench. Figure 10 (b).
Frame brace
Figure 10
Cross brace
13
Slot in frame brace
(a)
Tabs on tank panel
(b)