Burner Tube Cleaning Or Replacement - Weber Q 100 Owner's Manual

BURNER TUBE CLEANING OR REPLACEMENT

You will need: a flathead screwdriver .
A) Your Weber ® Q ® barbecue must be OFF and cool .
B) Turn gas OFF at source .
C) Open the lid .
D) Remove cooking grate .
Burner Tube Removal
A) Remove the ¼-20 x ½ inch screw that holds the burner tube to the cookbox (1) .
B) Carefully slide the burner tube out from the cookbox .
Burner Tube Cleaning
A) Look inside the burner with a flashlight (2) .
B) Clean the inside of the burner with a wire (a straightened-out coat hanger will
work) (3) .
C) Check and clean the air shutter opening at the ends of the burner . Check and clean
the valve orifice at the base of the valve . Use a steel bristle brush to clean outside of
burner . This is to make sure all the burner ports are fully open .
m CAUTION: Do not enlarge the burner ports when cleaning.
D) Lightly tap each burner to get debris and dirt out of the burner tube . Once the
spider/insect screens and burners are clean, reinstall the burners .
Burner Tube Reinstallation
A) To reinstall the burner tubes, reverse steps for "Burner Tube Removal" as previously
described .
m CAUTION: The burner openings (4) must be positioned
properly over the valve orifices (5).
m WARNING: After reinstalling the burners, the gas
connections should be leak checked with a soap and water
solution before using the barbecue. Refer to "CHECK FOR
GAS LEAKS."
◆
mAINTENANcE
1
5
4
2
3
WWW.WEbER.com
® 15