Weber Platinum II 3200 NG Owner's Manual page 21

Position slide bar assembly on the outside of the caster
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through frame and slide bar assembly and add
nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 29.
Notch to the front
Slide bar
Figure 29
To lower table: Pull support rod up to disengage slide lock,
and lower table. To raise table, lift table up and engage slide
in locked position. Figure 30.
Unlocked position
Figure 30
View from front
of barbecue
Support rod
View from rear
of barbecue
Slide
Locked position
Step 22
Install right hand swing table
You will need: swing table end bracket, two 10-24 hex
nuts, two 10-24 x 1 3/4 inch machine screws, right hand
slide bar assembly, swing table, four nylon washers,
screwdriver and pliers.
Allow the slide bar to hang down. Push the support rod
into the lower support bracket. Figure 31 (a). Swing the
rod up so you can slide the rod all the way inside the
locking tab. Figure 31 (b). The rod should swing freely
inside the locking tab. Figure 31 (c).
(b)
21
View from rear
(a)
Slide bar
assembly
Figure 31
(c)
Support rod