Weber Platinum II 3200 NG Owner's Manual page 15

Step 11
Check that all burner valves are off
You will need: one burner control knob.
Valves are shipped in the OFF position, but you should
check to be sure. Put the knob on each valve. Check by
pushing down and turning clockwise. If they do not turn,
they are off, proceed to the next step. Figure 12.
Figure 12
Step 12
Connect flexible hose to manifold
You will need: the 12 foot natural gas supply hose and a
3/4 inch wrench.
Thread fitting end of hose onto manifold. Figure 13 (a).
Tighten with wrench.
Figure 13
(a)
Step 13
Install side burner
You will need: side burner assembly, burner grate, and
manifold bracket.
WARNING: Make sure gas supply is OFF.
Slide the side burner assembly into the open end of the
right frame. Route the side burner hose around the tank
panel so it will not interfere with scale indicator rod.
The side burner hose is connected in the following
manner:
Slide back the collar of the quick disconnect on the
manifold. Push the male fitting of the side burner hose into
the quick disconnect, and maintain pressure. Slide the
collar closed. Figure 14 (a). Figure 14 (b) shows the quick
disconnect engaged.
Install burner grate. Check to be sure the side burner
valve is OFF. Push side burner control knob down and
turn clockwise. Figure 14.
Figure 14
Male fitting
of side burner
a)
Quick disconnect
engaged
b)
Side burner hose
15
Manifold side view
Manifold side view