Weber Platinum II 3200 NG Owner's Manual page 19

Step 19
Install tool holders, control panel and burner
control knobs
You will need: three tool holders, control panel, two Phillips
screws/washers, a Phillips screwdriver, and three burner
control knobs.
Hook the tool holders over the frame rail. Figure 25.
Set the control panel in place over both frame braces. (Hold
the Crossover Ignition button up while setting the control
panel in place.) Line up the holes in the control panel with
the holes in the inserts in the frame brace. Insert screws
and tighten with a Phillips screwdriver until snug. Do not
overtighten. Figure 25 (a).
Push on the burner control knobs. Figure 25 (b).
Insert in
frame brace
Crossover
Ignition Button
Tool holders
Figure 25
Step 20
Secure side burner
Pull the right hand swing table up. Stand to the right side
of the barbecue. Slightly pull back both side burner locks.
Slide the side burner toward the control panel. The locks
will snap into the slots in the front and back of the side
burner. Figure 26.
CAUTION: Make sure both locks have snapped
into place.
(a)
Control panel
Phillips screws/
washers
(b)
19
View from top
View from side
Figure 26