Assembly - Weber Platinum I 2200 LP Owner's Manual

Position slide bar assembly on the outside of the wheel
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through wheel frame and slide bar assembly and
add nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 29.
Notch
View from front
of barbecue
Figure 29
To lower table: Pull support rod up to disengage slide lock
and lower table. To raise table, lift table up and engage
slide in locked position. Figure 30.
Unlocked position
Figure 30
Slide bar
Wheel frame
Support rod
Slide
Locked position
Step 20
Complete accessory installation
You will need: work table, two accessory trays, Warm-Up
Basket, warming rack, thermometer, two tubing plugs and
a hammer.
Insert one end of the Weber Warm-Up Basket into the hole
in the right end of the lid and the other end into the slot in
the left end of the lid. Figure 31 (a).
Set the work tables onto the left and right side rails.
Figure 31 (b).
Set the accessory trays between the two frame connectors.
Figure 31 (c).
Set the warming rack into the slots at the rear of the
cooking box. Figure 31 (d).
Insert the thermometer into its holder. Figure 31 (e).
Insert tubing plugs into the ends of the frame. To fully seat
the plugs, you may have to tap them lightly with a hammer.
Figure 31 (f).
(d)
(b)
(c)
Figure 31
CAUTION: To keep the barbecue stationary, the tabs
on the locking casters should be in the down position.
21
(a)
(e)
(f)