Weber Platinum I 2200 LP Owner's Manual page 13

Step 8
Install manifold bracket
You will need: manifold bracket
Hook the bracket onto the manifold at the center burner
valve. Figure 9. Place your hand underneath the
bracket. Lift the bracket, manifold and cooking box
slightly as a unit and hook onto the frame brace.
Figure 9
Manifold bracket
Frame brace
Step 9
Install igniter
Note - The igniter wires are already attached to the Gas
Catcher Ignition Chamber and the igniter. This was done to
factory test the ignition system.
The igniter lock nut and igniter gasket are on the igniter.
Route the igniter and wires as shown. Figure 10 (a). Insert
the top of the igniter up through the large part of the
keyhole in the frame brace. Loosen the igniter lock nut and
slide the igniter to the rear of the keyhole with the igniter
gasket on top of the frame brace. Tighten the igniter lock
nut. Figure 10.
Note - If the igniter works loose, carefully tighten the igniter
lock nut with an adjustable wrench or pliers.
Figure 10
Frame brace Small part of keyhole
in frame brace
13
Igniter lock nut
Keyhole in
frame brace