ZyXEL Communications P-660RU-T1 v3 User Manual page 141

Table 40 Access Management > CWMP (continued)
LINK
Port
UserName
Password
Periodic
Inform
Interval
SAVE
CANCEL
P-660RU-Tx v3 User's Guide
DESCRIPTION
The default port for access to the ZyXEL Device from the management server is the
HTTP port, port 80. If you change it, make sure it does not conflict with another port on
your network and it is recommended to use a port number above 1024 (not a
commonly used port). The management server should use this port to connect to the
ZyXEL Device. You may need to alter your NAT port forwarding rules if they were
already configured.
The user name is used to authenticate the management server when connecting to
the ZyXEL Device. Type a user name of up to 255 printable characters found on an
English-language keyboard. Spaces and characters such as @#$%^&*()_+ are
allowed.
The password is used to authenticate the management server when connecting to the
ZyXEL Device. Type a password of up to 255 printable characters found on an
English-language keyboard. Spaces are not allowed.
Select Activated to have the ZyXEL Device periodically send information to the
management server (recommended if CWMP is enabled) or select Deactivated to not
have the ZyXEL Device periodically send information to the management server
The interval is the duration in seconds for which the ZyXEL Device must attempt to
connect with the management server to send information and check for configuration
updates. Enter a value between 1 and 86400 seconds.
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 19 CWMP
141