The Cwmp Setup Screen; Figure 69 Access Management > Cwmp; Table 40 Access Management > Cwmp - ZyXEL Communications P-660RU-T1 v3 User Manual

Chapter 19 CWMP

19.2 The CWMP Setup Screen

Use this screen to configure your ZyXEL Device to be managed by a management server.
Click Access Management > CWMP to display the following screen.
Figure 69 Access Management > CWMP
The following table describes the fields in this screen.
Table 40 Access Management > CWMP
LINK
CWMP Setup
CWMP
Login ACS
URL
User Name
Password
Connection
Request
Path
140
DESCRIPTION
Select Activated to allow the ZyXEL Device to be managed by a management server
or select Deactivated to not allow the ZyXEL Device to be managed by a
management server.
Configure this part of the screen to log into the management server.
Type the IP address or domain name of the management server. If the ZyXEL Device
is behind a NAT router that assigns it a private IP address, you will have to configure a
NAT port forwarding rule on the NAT router.
The user name is used to authenticate the ZyXEL Device when making a connection
to the management server. This user name on the management server and the ZyXEL
Device must be the same. Type a user name of up to 255 printable characters found
on an English-language keyboard. Spaces and characters such as @#$%^&*()_+ are
allowed.
The password is used to authenticate the ZyXEL Device when making a connection to
the management server. This password on the management server and the ZyXEL
Device must be the same. Type a password of up to 255 printable characters found on
an English-language keyboard.
Use this part of the screen to allow the management server to connect to the ZyXEL
Device after a successful login.
Type the IP address or domain name of the ZyXEL Device. The management server
uses this path to verify the ZyXEL Device.
P-660RU-Tx v3 User's Guide