Flush Mounted Installation - 2X8 Framing - Dimplex BLF50 Owner's Manual

Fireplace Installation
Figure 12
Mounting
hole
electric shock or injury to persons,
always use a licensed electrician.
Ensure that the On/Off Switch is set
to the Off position (refer to Opera-
tion section) and that the circuit on
which the fireplace is to be installed
has the power cut off at the service
panel until installation is complete.
3. Lift fireplace and insert into
opening (Figure 11).
4. Use bubble level (supplied) to
level the fireplace within the
framing. Adjust as required.
5. Drive four supplied mount-
ing screws through the four
mounting holes located in
each corner of the fireplace
chassis, into wall studs (Figure
12).
6. Refer to Front Glass Installa-
tion section, page 17 for final
installation procedures.
Figure 13
Flush Mounted Installation
- 2x8 Framing
CAUTION: Two people may
be required for various steps
of this procedure.
1. Prepare a wall with a framed
opening of 49 in. (124.5 cm)
wide x 18½ in. (47 cm) high
(Figure 13).
!
NOTE: The sizing has al-
lowed for 1/4" (6.4mm) around the
fireplace insert for ease of instal-
lation. This fireplace does not
require any additional venting.
2. Choose your method of sup-
plying power to the unit:
2 x 8 Framing
15