Setting The Display Brightness; Adjusting Speaker Levels; Muting The Av Receiver - Integra DTR-8.9 Instruction Manual

Basic Operations—Continued
This section explains functions that can be used with any
input source.
4 5
Tape Tuner
7 8
D.TUN
Phono Net/USB
+10 0 Clear
--/--- 10 11
Input Selector
Macro
1 2
Remote Mode
DVD VCR
CDR/MD/Dock
TV Cable Net/USB
SAT
Dimmer
Dimmer
+
CH
Enter
Disc
Album
-
Prev
CH
Display
Display
Rec Playlist
Listening Mode
Stereo Surround
Repeat Audio Subtitle
Direct
CH Sel
Test Tone CH Sel Level-
Open/Close Video Off
Audio Sel L Night
VCR DVD
RC- 688 M
Phones Dimmer Display

Setting the Display Brightness

You can adjust the brightness of the display.
Remote Press the remote controller's
controller
[Dimmer] button repeatedly to
Dimmer
select: Normal, Dim, or Dimmer.
You can also use the AV receiver's
[Dimmer] button (not Australian mod-
els).
AV receiver
-
6
CD
9
TV VOL
12
3 Zone 3
Press
[Receiver]
CD Zone 2
first
Receiver
Tape/AMP
Sleep
Sleep
VOL
Muting
Muting
Random
Play Mode
THX All ST
Level+
Level – +
Re-EQ
HDD

Adjusting Speaker Levels

You can adjust the volume of each speaker while listen-
ing to an input source. These temporary adjustments are
cancelled when the AV receiver is set to Standby.
Use the remote controller's [CH
CH Sel
Sel] button to select each
speaker, and use the [Level–] and
[Level+] buttons to adjust the vol-
ume.
Level- Level+
You can adjust the volume of each
speaker from –12 dB to +12 dB
(–15 dB to +12 dB for the subwoofer).
Notes:
• You cannot use this function while the AV receiver is
muted.
• Speakers that are set to "No" or "None" in the
"Speaker Config" cannot be adjusted (see page 106).
■ Headphones
While a pair of headphones is connected, you can use the
[CH Sel], [Level–], and [Level+] buttons to adjust the
volume of each headphone speaker (left and right), from
–12 dB to +12 dB each.
These settings are stored when the AV receiver is set to
Standby.

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.
Press the remote controller's
[Muting] button.
Muting
The output is muted and the MUTING
indicator flashes on the display, as
shown.
To unmute the AV receiver, press the
[Muting] button again, or adjust the
volume.
The Mute function is cancelled when
the AV receiver is set to Standby.
Tip:
You can specify how much the output is muted with the
"Muting Level" setting (see page 125).
67