Speaker Setup - Integra DTR-50.1 Instruction Manual

Advanced Setup—Continued
HDMI Input
See "HDMI Input Setup" on page 47.
Component Video Input
See "Component Video Input Setup" on page 48.
Digital Audio Input
See "Digital Audio Input Setup" on page 49.

Speaker Setup

Some of the settings in this section are set automatically by Audyssey MultEQ
(see page 53).
Here you can check the settings made by Audyssey MultEQ
ally, which is useful if you change one of the connected speakers after using Audyssey MultEQ
Speaker Setup.
Note:
The Speaker Setup cannot be carried out while headphones are connected to the AV receiver.
1 Press the [Receiver] button followed by
the [Setup] button.
The main menu appears onscreen.
If the main menu doesn't appear, make sure the
appropriate external input is selected on your TV.
2
Use the Up and Down [ ]/[ ] buttons to
select "2. Speaker Setup", and then press
[Enter].
3 Use the Up and Down [ ]/[ ] buttons to
select the submenu, and then press
[Enter].
Speaker Settings
See "Speaker Settings" on page 50.
Speaker Configuration
With these settings, you can specify which speakers are connected and a crossover frequency for each speaker. Specify
"Full Band" for speakers that can output low frequency bass sounds adequately, for example, speakers with a good
sized woofer. For smaller speakers, specify a crossover frequency. Sounds below the crossover frequency will be
output by the subwoofer instead of the speaker. Refer to your speaker's manuals to determine the optimum crossover
frequencies.
If you set up your speakers using Audyssey MultEQ
ally that any THX speakers are set to "80Hz(THX)" crossover.
Subwoofer
*1
Front
®
Room Correction and Speaker Setup, please make sure manu-
Yes: Select if a subwoofer is connected (default).
No: Select if no subwoofer is connected.
Full Band, 40Hz, 45Hz, 50Hz, 55Hz, 60Hz, 70Hz, 80Hz(THX) (default), 90Hz,
100Hz, 110Hz, 120Hz, 130Hz, 150Hz, 200Hz
®
Room Correction and Speaker Setup
®
Room Correction and Speaker Setup, or set them manu-
4 Use the Up and Down [ ]/[ ] buttons to
select setting, and then use the Left and
Right [ ]/[ ] buttons to set them.
5
When you've finished, press the [Setup]
button.
The setup menu closes.
®
Room Correction and
95