Listening To The Radio; Using The Tuner - Integra DTR-50.1 Instruction Manual

Listening to the Radio

Using the Tuner

With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets
for quick selection.
Listening to the Radio
Use the [Tuner] input selector
button to select either AM or FM.
In this example, FM has been selected.
Each time you press the [Tuner] button,
the input source changes between AM
and FM.
Band
(Actual display depends on country.)
Tuning into Radio Stations
■ Auto Tuning Mode
1
Press the [Tuning Mode] button
so that the AUTO indicator
appears on the display.
2
Press the Tuning Up or Down [ ]/
[ ] buttons.
Searching stops when a station is
found.
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator appears on the display, as shown.
64
Tuner Tuning /
Tuning Mode
Frequency
■ Manual Tuning Mode
1
Press the [Tuning Mode] button
so that the AUTO indicator disap-
pears from the display.
2
Press and hold the Tuning Up or
Down [ ]/[ ] buttons.
The frequency stops changing when
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
This model changes FM/AM frequency in 200k/10k (or
50k/9k) Hz steps.
In Manual Tuning mode, FM stations will be in mono.
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
■ Tuning into Stations by Frequency
You can tune into AM and FM stations directly by enter-
ing the appropriate frequency.
1
Press the [Tuner] button repeat-
edly to select AM or FM, followed
Remote
by the [D.TUN] button.
controller
(Actual display depends on country.)
2
Within 8 seconds, use the num-
ber buttons to enter the fre-
Remote
quency of the radio station.
controller
For example, to tune to 87.5 (FM),
press 8, 7, 5.
TUNED
AUTO
FM STEREO