Yamaha Morphous CP250W Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
CAUTION:
• Do not operate the engine
above 9000 r/min.
• This model is equipped with an
engine speed limiter, which pre-
vents the engine speed from ex-
ceeding approximately 9000 r/
min.
3
Odometer, clock and tripmeter
modes
Pushing the "SELECT" button switches
the display between the odometer
mode "ODO", clock mode and the trip-
meter modes "TRIP" in the following or-
der:
ODO -» CLOCK -» TRIP (A) -» TRIP
(B) -» ODO
When approximately 4 L (1.06 US gal)
(0.88 Imp.gal) of fuel remains in the fuel
tank, the fuel meter and fuel level warn-
ing indicator will start flashing, and the
display will automatically change to the
fuel reserve tripmeter mode "F TRIP"
and start counting the distance traveled
from that point. In that case, pushing
the "SELECT" button switches the dis-
play between the various tripmeter,
ECA11630
clock and odometer modes in the fol-
lowing order:
F TRIP -» TRIP (A) -» TRIP (B) -»
ODO -» CLOCK -» F TRIP
1. Fuel reserve tripmeter
To reset a tripmeter, select it by push-
ing the "SELECT" button until "TRIP" or
"F TRIP" begins flashing ("TRIP" or "F
TRIP" will only flash for five seconds).
While "TRIP" or "F TRIP" is flashing,
push the "RESET" button for at least
one second. If you do not reset the fuel
reserve tripmeter manually, it will reset
itself automatically and the display will
return to the prior mode after refueling
and traveling 5 km (3 mi).
NOTE:.
The display cannot be changed back to
"F TRIP" after pushing the "RESET"
button.
Clock mode
To set the clock:
1. Push the "SELECT" button and
2. When the hour digits start flashing,
3. Push the "SELECT" button, and
4. Push the "RESET" button to set
5. Push the "SELECT" button and
Fuel meter
With the key in the "ON" position, the
fuel meter indicates the amount of fuel
in the fuel tank. The display segments
of the fuel meter disappear towards "E"
(Empty) as the fuel level decreases.
When the fuel level reaches the bottom
3-4
"RESET" button together for at
least two seconds.
push the "RESET" button to set the
hours.
the minute digits will start flashing.
the minutes.
then release it to start the clock.