Yamaha TMAX XP500A Owner's Manual page 23

1
1. Clock
2. Oil change indicator "OIL"
1
2
1. "RESET" button
2. "SELECT" button
The multi-function display is equipped
with the following:
G a tachometer (which shows engine
speed)
INSTRUMENT AND CONTROL FUNCTIONS
G
an odometer (which shows the to-
2
tal distance traveled)
G
two tripmeters (which show the
distance traveled since they were
last set to zero)
G
a fuel reserve tripmeter (which
shows the distance traveled when
the remaining fuel in the fuel tank
reaches approximately 3.0 L (0.79
US gal) (0.66 Imp.gal))
G a self-diagnosis device
G a clock
G
an oil change tripmeter (which
shows the distance traveled since
the last engine oil change)
G
a V-belt replacement tripmeter
(which shows the distance trav-
eled since the last V-belt replace-
ment)
NOTE:
G Be sure to turn the key to "ON" be-
fore using the "SELECT" and
"RESET" buttons.
G
When the key is turned to "ON", all
of the display segments of the
multi-function display will appear
one after the other and then disap-
pear, in order to test the electrical
Tachometer
The tachometer allows the rider to
monitor the engine speed and keep it
within the ideal power range.
CAUTION:
Do not operate the engine in the ta-
chometer red zone.
Red zone: 8250 r/min and above
Clock
To set the clock:
1. Push the "SELECT" button and
2. When the hour digits start flashing,
3. Push the "SELECT" button, and
4. Push the "RESET" button to set
5. Push the "SELECT" button and
3-7
circuits.
"RESET" button together for at
least two seconds.
push the "RESET" button to set the
hours.
the minute digits will start flashing.
the minutes.
then release it to start the clock.
2
ECA10031
3
4
5
6
7
8
9