Vax 88000 User Manual page 14

FAQ's
WARNING: To reduce the risk of personal injury, unplug the carpet washer before performing
maintenance/troubleshooting checks.
Problem
Cleaner won't run
Vacuum won't pick up/loss of
suction
Dust escaping from the
Vacuum
Cleaner won't dispense
solution
13
Cause
Power cord not firmly pushed into a
mains socket.
Blown house fuse or tripped circuit
breaker.
Dirty water tank is not installed correctly.
Dirty water tank is full.
Broken or worn belt.
Brush roll is worn.
Nozzle/dirt passage is clogged.
Float prematurely activated.
Dirty water tank is full.
Dirty water tank is not installed properly.
Solution reservoir not installed correctly.
Solution reservoir not installed correctly.
Solution tank empty.
AU: 1300 361 505 / NZ: 0800 800 900
Solution
Plug cord in firmly.
Check fuse/breaker. Replace fuse or
reset breaker.
Refer to page 10 for fitting information.
See 'Emptying the dirty water tank'.
Replace the belt.
Replace the brush roll.
Remove obstruction.
Refer "Important" notes on page 9.
Empty dirty water tank.
Refer to page 10 for fitting information.
See 'How to operate your cleaner'.
See 'How to operate your cleaner'.
Fill tank see page 5.
Vax Service line