Automatic Timer; The Timer; Automatic Time Limitation; Cleaning Protection - Siemens EH6..ME3.. Instruction Manual

Automatic timer

With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note: The cooking time of a zone may be cancelled or
changed:
Press the 0 symbol several times until the required
indicator lights up. Change the cooking time in the
programming panel, or set to

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.

Automatic time limitation

If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. On the hotplate display,
flash alternately.

Cleaning protection

Cleaning the control panel while the range is on may change
the settings.
In order to avoid this, the range has a cleaning protection
function. Press the symbol. An audible signal sounds. The
#
control panel is locked for 35 seconds. The surface of the

Basic settings

The appliance has various basic settings. These settings may
be adapted to the needs of the user.
Indicator Function
Childproof lock
™‚
‹ Deactivated.*
Activated.
‚
™ƒ Audible signals
Most signals activated.
‹
‚ Some signals deactivated.
All signals activated.*
ƒ
™... Set according to altitude
‚ - ƒ Reduction.
„ Basic setting.*
... - Š Volume.
™† Automatic timer
‹ Switched off.*
- Automatic shut-off time
‚ ŠŠ
*Factory setting
x
‹‹ .
and
"
Programming
Press the symbol several times until the
0
1.
up. lights up in the time program function display.
‹‹
Select the desired time in the programming panel.
2.
The timer starts to count down after a few seconds.
Once the time has elapsed
A warning beep sounds. In the time program function display
is shown, and the
‹‹
the indicators turn off.
Pressing the symbol turns off the indicators and stops the
0
beep.
Changing or cancelling the time
Press the symbol several times until the
0
up. Change the cooking time in the programming panel, or set
to .
‹‹
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
‰
control panel can now be cleaned without risk of changing the
settings.
Note: The lock does not affect the main switch. The range may
be switched off when desired.
W
indicator comes on. After 10 seconds
W
indicator lights
W
indicator lights
15