Table of Contents
Advertisement
If the previous setting from 6 to 10 is pressed in the
programming panel , the cooking time is increased by one
minute, if it is held down the time is automatically increased to
99 minutes.
Once the time has elapsed
The hotplate switches off. The beep sounds and the display
comes on
‹‹
for 10 seconds. The
Pressing the
0
symbol turns off the indicators and stops the
beeping.
Changing or cancelling the time
Press the
0
symbol of the desired hotplate. Change the
cooking time in the programming panel, or set to
Automatically switch off a hotplate with the cooking sensor
function
When cooking using the sensor system, the programmed
cooking time begins to count down once the hotplate reaches
the desired temperature.
Automatically switch off a hotplate with the deep-frying
function
When cooking using the deep-frying function, the programmed
cooking time begins to count down once the selected hotplate
reaches the desired temperature.
Note: Any cooking time can be programmed up to 99 minutes.
Automatic timer
With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Automatic time limitation
If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. The
heat indicator
/
flash alternatively in the display.
œ
•
Cleaning protection
Cleaning the control panel while the range is on may change
the settings.
In order to avoid this, the range has a cleaning protection
function. Press the
symbol. An audible signal sounds. The
#
control panel is locked for 35 seconds. The surface of the
Basic settings
The device has several basic settings. These settings may be
adapted to the needs of the user.
Indicator
Function
Childproof lock
™‚
Off.*
‹
‚
On.
*Factory settings
16
x
indicator lights up.
‹‹
.
symbol and the residual
"‰
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note: The cooking time of a hotplate may be cancelled or
changed:
Press the
0
symbol of the desired hotplate. Change the
cooking time in the programming panel, or set to
Timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. The hob must be switched
on. The timer can be set for any hotplate not turned on. This
function does not automatically switch off a hotplate.
How to program
Press the symbol
for the hotplate, the indicator
0
1.
turned on.
lights up in the time program function display.
‹‹
Select the desired time in the programming panel.
2.
The timer starts to count down after a few seconds.
Once the time has elapsed
A warning beep sounds. In the time program function display
is shown, and the
indicator comes on. After 10 seconds
‹‹
W
the indicators turn off.
Pressing the
0
symbol turns off the indicators and stops the
beep.
Changing or cancelling the time
Press the
0
symbol of the desired hotplate. Change the
cooking time in the programming panel, or set to
Note: When the timer is activated, the corresponding hotplate
is locked. First turn off the timer and then the hotplate.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
control panel can now be cleaned without risk of changing the
settings.
Note: The lock does not affect the main switch. The range may
be switched off when desired.
‹‹
.
is
W
.
‹‹
Advertisement
Table of Contents
