Procedures For Registration - Epson EMP Operation Manual

Registering and deleting projectors for monitoring

Procedures for registration

Procedure
A
Select the projector(s) to be registered from the displayed
list, and then click "Edit".
The following window will be displayed.
Make the necessary settings while referring to the following table.
Enter the name of the projector(s) to be displayed in Grouping
Display name
view or Detail list view.
Up to a maximum of 32 bytes can be entered. A space cannot
be used as the first character.
Select the icon(s) to be displayed in Grouping view or Detail
Display icon
list view.
Parent group Select when registering a projector in a group.
If no groups have been created, this cannot be selected.
s "Registering several projectors to a monitoring group all at
once" p.16
Projector name This shows the name that has been registered on the projector.
IP address This shows the IP address for the registered projector.
This cannot be selected when registering projectors using
Use Serial W
automatic search.
TCP/IP
conversion
adaptor.
Port Number This cannot be selected when registering projectors using
automatic search.
If a Monitor Password has been set for the projector, be sure to
Monitor
enter the Monitor Password that has been set. If the correct
Password
password is not entered at this time, it will not be possible to
monitor and control the projector even though it is registered.
You can enter some kind of memo about the projector. The
Description
details you enter here will be displayed at the projector
properties.
Up to a maximum of 60 bytes can be entered.
Select this when you want monitoring to start.
Monitor
B
After entering the details, click "Register" to start the
registration. When the message is displayed, click "OK".
To continue registering other projector(s), repeat Steps 1 and 2.
Projectors that have been registered using automatic search are
q
searched for again by projector name each time EMP Monitor is
started.
11