Setting The Top Priority Playback Layer For Super Audio Cds - Marantz SA8005 Owner's Manual

Contents
Setting the top priority playback layer
for Super Audio CDs
The layer that is played with priority when the disc is loaded can be set.
1
Press INPUT to select the playback media mode to
"Disc".
2
Check that no disc is loaded.
• If the layer is switched while the disc is being loaded, the playback
layer switches for that disc, but the top priority playback layer
setting itself does not change.
3
Press SOUND MODE and switch to the layer you want
to set.
STEREO (Default) : Plays back the 2-channel area of the Super
Audio CD.
MULTI : Plays back the multi-channel area of the Super Audio
CD. The analog output of this unit outputs a down-mixed
2-channel signal.
CD : Plays back the CD layer of the Super Audio CD.
Front panel Display
Connections Playback
Rear panel
Settings
%
• When a disc is loaded after the setting has been made, the contents
recorded on the set layer are displayed.
• If a disc that does not contain the layer set for top priority playback
is loaded, the contents recorded on another layer are displayed
automatically.
• This setting is stored in the memory and is not cleared even when the
disc holder is opened or closed or the power is turned off. To change the
setting, repeat the procedure above.
• The priority playback layer cannot be set when a disc is inserted or
"Open" is shown on the display.
• If the area and layer have not been set for a disc, the priority playback
order is as follows:
q STEREO w MULTI
30
Remote
Tips Appendix
e CD
Index