The Broadband Screen - ZyXEL Communications P-2612HNU-F1 User Manual

Chapter 5 Broadband

5.2 The Broadband Screen

The ZyXEL Device must have a WAN interface to allow users to use the Ethernet
WAN port or DSL port to access the Internet. Use the Broadband screen to view,
remove or add a WAN interface.
Note: The ATM and Ethernet layer-2 interfaces cannot work at the same time.
Click Network Setting > Broadband. The following screen opens.
Figure 16 Network Setting > Broadband
The following table describes the fields in this screen.
Table 6 Network Setting > Broadband
LABEL
Switch WAN Mode
Type
Add new WAN
Interface
Internet Setup
#
Name
Type
Mode
Encapsulation
VPI
VCI
94
DESCRIPTION
The default WAN mode is ADSL. If you prefer not to use a DSL line
and you have another broadband modem or router (such as ADSL)
available, you can select EtherWAN from the drop-down list box and
click Switch WAN Interface. The ZyXEL Device will use Ethernet
WAN as the WAN mode.
Click this to create a new WAN interface.
This is the index number of the connection.
This is the service name of the connection.
This shows the type of interface used by this connection.
This shows whether the connection is in routing mode or bridge mode.
This shows the method of encapsulation used by this connection.
This is the Virtual Path Identifier (VPI).
This is the Virtual Channel Identifier (VCI).
P-2612HNU(L)-FxF User's Guide