The Sip Account Screen - ZyXEL Communications P-2612HNU-F1 User Manual

Table 56 VoIP > SIP > SIP Service Provider (continued)
LABEL
Min-SE
Dialing Interval Selection
Dialing Interval
Selection
Bound Interface Name
Bound Interface
Name
PSTN Fail Over
("L" models
only)
Apply
Cancel

16.3 The SIP Account Screen

The ZyXEL Device uses a SIP account to make outgoing VoIP calls and check if an
incoming call's destination number matches your SIP account's SIP number. In
order to make or receive a VoIP call, you need to enable and configure a SIP
account, and map it to a phone port. The SIP account contains information that
allows your ZyXEL Device to connect to your VoIP service provider.
See Section 16.6 on page 239
To access the following screen, click VoIP > SIP > SIP Account.
Figure 92 VoIP > SIP > SIP Account
P-2612HNU(L)-FxF User's Guide
DESCRIPTION
Enter the minimum number of seconds the ZyXEL Device lets a SIP
session remain idle (without traffic) before it automatically disconnects
the session. When two SIP devices start a SIP session, they must agree
on an expiration time for idle sessions. This field is the shortest
expiration time that the ZyXEL Device accepts.
Enter the number of seconds the ZyXEL Device should wait after you
stop dialing numbers before it makes the phone call. The value depends
on how quickly you dial phone numbers.
If you select LAN or AnyWAN, the ZyXEL Device automatically
activates the VoIP service when any LAN or WAN connection is up.
If you select MultiWAN, you also need to select the pre-configured
WAN connections. The VoIP service is activated only when the selected
WAN connection is up.
Select this check box if you want to redirect the outgoing calls to the
PSTN line (that do not use the Internet) when your SIP account is
unregistered or SIP call has failed.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
for how to map a SIP account to a phone port.
Chapter 16 VoIP
231