Rack Mounting - ZyXEL Communications GS1100-16 User Manual

See Table 6 on page 15
Table 6 Distance between the centers of the holes for wall mounting
MODEL
GS1100-8HP
GS1100-16
GS1100-24E
Screw the two screws provided with your Switch into the wall (see the figure in step 2). Use screws
1
with 6 mm ~ 8 mm (0.24" ~ 0.31") wide heads. Do not screw the screws all the way in to the wall;
leave a small gap between the head of the screw and the wall.
The gap must be big enough for the screw heads to slide into the screw slots and the connection
cables to run down the back of the Switch.
Note: Make sure the screws are securely fixed to the wall and strong enough to hold the
weight of the Switch with the connection cables.
Align the holes on the back of the Switch with the screws on the wall. Hang the Switch on the
2
screws.
The Switch should be wall-mounted horizontally. The Switch's side
panels with ventilation slots should not be facing up or down as this
position is less safe.

2.3.2 Rack Mounting

The Switch can be mounted on an EIA standard size, 19-inch rack or in a wiring closet with other
equipment. Follow the steps below to mount your Switch on a standard EIA rack using a rack-
mounting kit.
Rack-mounted Installation Requirements
• Two mounting brackets.
GS1100 Series User's Guide
for how far apart to place the screws.
DISTANCE
120 mm
148 mm
207 mm
Chapter 2 Hardware Description and Connection
15