S Can; T Emporary C Hannel L Ockout; S Can D Elete /A Dd; P Riority S Can - Kenwood TK-5720 User Manual

Scan monitors for signals on the transceiver channels. While scanning, the
transceiver checks for a signal on each channel and only stops if a signal is
present.
To begin scanning, press the key programmed as Scan.
• The icon appears on the display.
• When a signal is detected on a channel, Scan pauses at that channel. The transceiver
will remain on the busy channel until the signal is no longer present, at which time Scan
resumes.
To stop scanning, press the Scan key again.
Note: To use Scan, there must be at least 2 channels in the scan sequence.
T c
emporAry hAnnel
During scan, you can temporarily remove specific channels from the scanning
sequence by selecting them and pressing the key programmed as Scan Delete/
Add.
• The channel is no longer scanned. However, when scanning is ended and restarted, the
channels are reset and deleted channels will again be in the scanning sequence.
S d /A
cAn eleTe dd
You can add and remove zones and/or channels to and from scan.
1 Select your desired zone and/or channel.
2 Press the key programmed as Zone Delete/Add (to add/remove zones) or
Scan Delete/Add (to add/remove channels).
• You can also press and hold the key programmed as Scan Delete/Add to add/
remove zones.
p S
rioriTy cAn
Note: To use Priority Scan, a Priority channel must be programmed.
When using a single Priority channel, the transceiver will automatically change to
the Priority channel when a call is received on that channel, even if a call is being
received on a normal channel.
When using dual Priority channels, Priority channel  is given precedence over
Priority channel 2. So, if a call is received on Priority channel  while a call is
already on Priority channel 2, the transceiver will change to Priority channel .
2
SCAN
l
ockouT