Connecting To An External Battery - Xantrex XPower 300 Owner's Manual

5. Turn the compressor off before removing nozzle adaptor
6. Remove nozzle adaptor from valve connector and store
Note: Leave the thumb latch in the open position for
storing to relieve pressure on the internal mechanism.

Connecting to an External Battery

You can extend battery operating times by connecting the
XPower Powerpack to a larger external battery.
For example, an external 60 amp-hour battery gives
approximately three and one-half times the operating time of
the XPower Powerpack internal 20 amp-hour battery.
To connect the XPower Powerpack to an external battery
using the jump-start cables:
1. Connect the jump-start cables to the Jumper Cable Port
2. Connect the red positive (+) clip of the jump-start cables
3. Connect the black negative (–) clip of the jump-start
from valve stem.
in storage compartment.
WARNI NG: Acid spills
Use a sealed, non-spillable battery for indoor use.
Common auto and marine batteries are not suitable for
indoor use unless their fumes are vented outdoors.
Common auto and marine batteries contain acid, which
is hazardous if spilled. Wear eye protection and
protective clothing when connecting the XPower
Powerpack to an external battery.
on the left side of the XPower Powerpack.
to the red positive (+) terminal of the external battery.
cables to the black negative (–) terminal of the external
battery.
Connecting to an External Battery
23