Rear Panel - TP-Link TL-SL2210 Installation Manual

Smart Switch
Port Feature
TL-SL2210
TL-SL2218
TL-SL2428
TL-SL2452
Reset(RESET)
With the switch powered on, press Reset button for five seconds to reset the
software setting to its factory default settings.
10/100Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps or 100Mbps. Each
has a corresponding 10/100M LED.
10/100/1000Mbps RJ45 Port
Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or
1000Mbps. Each has a corresponding 1000M LED.
SFP Port
Designed to install the SFP module. TL-SL2218/TL-SL2428 features some SFP
transceiver slots that are shared with the associated RJ45 ports. The associated
two ports are referred as a "Combo" port, which means they cannot be used
simultaneously, otherwise only SFP port works. Meanwhile, the associated two ports
share the same LED. For TL-SL2218, Port 17 shares the same LED with Port 17F and
Port 18 shares the same LED with Port 18F; for TL-SL2428 Port 27 shares the same
LED with Port 27F and Port 28 shares the same LED with Port 28F.

Rear Panel

■
The rear panel of TL-SL2210 is shown as Figure 1-5.
Grounding Terminal
Power Socket
Introduction
03
Model 10/100Mbps RJ45 Port 10/100/1000Mbps RJ45 Port
8
16
24
48
Figure 1-5
1
2
4
2
Rear Panel of TL-SL2210
SFP Port
1
2(Combo1
2(Combo1
2