Table of Contents
Advertisement
STEP 8 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
2-wire with a ground wire, a ground must be provided
by the installer. When house wiring is aluminum, be
sure to use UL approved anti-oxidant compound and
aluminum-to-copper connectors.
ATTENTION –
maison n'est pas du type à deux fils avec un fil de
terre, l'installateur doit fournir un circuit de terre.
Quand les fils de la maison sont en aluminium, il
prendre soin d'utiliser de la pâte antioxidation
approuvée par UL et des connecteurs pour
l'aluminium-cuivre.
STEP 9 INSTALL THE MOTOR
Attachment
Slot
Screw F
Attachment
Slot
• From the inside of the hood, slip motor into the
attachment slot on the left.
• Rotate motor upwards until it snaps into the spring
clip on the right.
• Secure the motor to the hood with the machine
screw and lock washer (Screw is marked with red
paint.)
• Plug blower cable into the connector on the blower.
Installation Instructions
If house wiring is not
Si le câblage de la
Outlet
Spring
Clip
Attachment Screw
and Washer
Spring
Clip
• Install strain relief onto the knockout of the junction
box.
• Insert house wiring through strain relief and tighten.
• Use wire nuts to connect incoming ground to green,
white to white and black to black.
• Push wires into junction box and replace cover. Be sure
wires are not pinched.
IMPORTANT: Connector
ends are designed to
mate only one way.
Match flat and round
connectors as shown.
• Plug cable at the top of the hood into the junction box
connector. Route cable so it won't be pinched or
damaged when the duct cover is lowered.
16
Top
Junction Box
Advertisement
Table of Contents
