Advertisement
Operation Guide 5123
Adjusting the Home Positions
Strong magnetism or impact can cause the hands and/or date of the watch to be off.
If this happens, perform the applicable home position adjustment procedures in this
section.
Note
Any time after you enter the home position adjustment mode in step 1 of the following
procedure, you can return to the Timekeeping Mode by pressing A. The watch also
will return to the Timekeeping Mode automatically if you do not perform any operation
for about two or three minutes in the home position adjustment mode. In either case,
any adjustments you made before the watch returned to the Timekeeping Mode will
be applied.
To adjust the home positions
1.
Hold down
C for about two seconds until the watch beeps twice and enters the
Timekeeping Mode.
2.
Hold down
D for about three seconds until the watch beeps.
•
The watch is now in the home position adjustment
mode.
•
The watch will exit the adjustment mode automatically
if you do not perform any operation for about two or
three minutes.
•
First is
x Second Hand home position adjustment.
•
If the
x Second Hand moves to 12 o'clock, it is in the
correct home position. If it doesn't, use D to move it
to 12 o'clock.
•
Each press of
mode will cycle through the adjustment settings as
shown below.
x Second
z Hour/ c Minute/ v Upper Left Dial Hand
m Day
n Right Dial Hand
3.
After confirming that the
x Second Hand is at the proper home position, press C.
This will switch to z Hour Hand and c Minute Hand home position adjustment.
•
The
z Hour Hand and c Minute Hand are at their proper home positions if
they both move to 12 o'clock, and if the v Upper Left Dial Hand is pointing at
hour 24. The v Upper Left Dial Hand also will move along with z Hour Hand
movement, and cannot be adjusted individually. If the hands are not positioned
correctly, use D (+) and B (–) to move them to their proper home positions.
4.
After confirming that the
Hand are in their correct home positions, press C. This
will switch to b Lower Left Dial Hands home position
adjustment.
•
The
b Lower Left Dial Hands are at their proper home
positions if they both move to 12 o'clock. If the hands
are not positioned correctly, use D (+) and B (–) to
move them to 12 o'clock.
5.
After confirming that the
the correct home positions, press C. This will advance
to n Right Dial Hand home position adjustment.
•
The
n Right Dial Hand is in the correct home position
if it is pointing at 12 o'clock. If it isn't, use D (+) and
B (–) to move it to 12 o'clock.
6.
After confirming that the
correct home position, press C. This will advance to
m Day home position adjustment.
•
The
m Day is in the correct home position if it
shows 1. If it doesn't, use D (+) and B (–) to change
the day to 1.
7.
Press
A to return to the Timekeeping Mode.
•
The
m Day moves to the current day, and then the z Hour Hand and the
c Minute Hand move to the current time. Wait until everything stops moving.
Troubleshooting
Hand Movement and Position
■ ■ I lost track of what mode the watch is in.
Refer to "To select a mode". To return directly to the Timekeeping Mode from any
other mode, hold down C for about two seconds.
■ ■ The x Second Hand is moving at two-second intervals.
■ ■ All the watch's hands are stopped at 12 o'clock and none of the buttons work.
Power may be low. Expose the watch to light until the x Second Hand starts moving
normally, at one-second intervals.
■ ■ The hands of the watch suddenly start moving at high speed, even when I do
not perform any operation.
This could be due to any one of the following causes. In all cases, the hand movement
does not indicate malfunction, and should stop shortly.
•
The watch is recovering from a sleep state.
•
The watch is returning to the Timekeeping Mode automatically from the Alarm
Mode.
■ ■ Hands suddenly stop moving. Button operation also is disabled.
The watch may be in the power recovery mode. Do not perform any operation until the
hands return to their normal positions (in about 15 minutes). The hands should return
to their correct positions when normal operation returns. To help power recover, leave
the watch in a location where it is exposed to light.
■ ■ The current time setting is off by hours.
Your Home City setting may be wrong. Check your Home City setting and correct it,
if necessary.
■ ■ The current time setting is off by one hour.
Use the procedure under "To toggle the Home City time between standard time and
daylight saving time" to change the STD/DST setting.
■ ■ The hands and/or day indications are off.
This could indicate that the watch has been exposed to magnetism or strong impact,
which has caused problems with proper hand and day alignment. Adjust the watch's
hand and day home position alignment.
C in the home position adjustment
b Lower Left Dial Hands
z Hour Hand and c Minute
b Lower Left Dial Hands are in
n Right Dial Hand is in the
World Time Mode
■ ■ The World Time indicated by the b Lower Left Dial Hands in the World Time
Mode is one hour off from the actual time in the selected time zone.
The STD (standard time)/DST (daylight saving time) setting of the selected World
Time City may be wrong. Select the correct STD (standard time)/DST (daylight saving
time) setting.
■ ■ The World Time indicated by the b Lower Left Dial Hands in the World Time
Mode is off.
Your Home City setting may be wrong. Check your Home City setting and correct it,
if necessary.
Charging
■ ■ The watch does not resume operation after I expose it to light.
This can happen after the power level drops to Level 3. Continue exposing the watch
to light until the x Second Hand starts moving normally (at one-second intervals).
■ ■ The x Second Hand starts moving at one-second intervals, but then suddenly
returns to move at two-second intervals.
The watch probably is not sufficiently charged yet. Continue keeping it exposed to
light.
Specifications
Accuracy at normal temperature: ±15 seconds a month
Timekeeping: Hour, minutes (hand moves every 10 seconds), seconds, 24-hour,
day, day of the week
Calendar system: Full Auto-calendar pre-programmed from the year 2000 to 2099
Other: Home City code (can be assigned one of 29 city codes and Coordinated
Universal Time); Daylight Saving Time (summer time) / Standard Time
Stopwatch: Measuring capacity: 23'59.99"
Measuring unit: 1/100 second
Measuring mode: Elapsed time, split time
World Time: 29 cities (time zones) and Coordinated Universal Time
Other: Standard Time/Daylight Saving Time (summer time); Home City/World Time
City swapping
Alarm: Daily alarm
Other: Power Saving
Power Supply: Solar cell and one rechargeable battery
Approximate battery operating time: 6 months (no exposure to light after a full
charge; 10 seconds alarm beeper operation per day)
City Code Table
City Code
PAGO PAGO
( P P G )
HONOLULU
( H N L )
ANCHORAGE
( A N C )
LOS ANGELES
( L A X )
DENVER
( D E N )
CHICAGO
( C H I )
NEW YORK
( N Y C )
SANTIAGO
( S C L )
RIO
Rio De Janeiro
F. DE NORONHA
( F E N )
Fernando de Noronha
PRAIA
( R A I )
UTC
LONDON
( L O N )
PARIS
( P A R )
ATHENS
( A T H )
JEDDAH
( J E D )
TEHRAN
( T H R )
DUBAI
( D X B )
KABUL
( K B L )
KARACHI
( K H I )
DELHI
( D E L )
DHAKA
( D A C )
YANGON
( R G N )
BANGKOK
( B K K )
HONG KONG
( H K G )
TOKYO
( T Y O )
ADELAIDE
( A D L )
SYDNEY
( S Y D )
NOUMEA
( N O U )
WELLINGTON
( W L G )
•
Based on data as of December 2009.
•
The rules governing global times (UTC offset and GMT differential) and summer
time are determined by each individual country.
UTC Offset/
City
GMT Differential
Pago Pago
–11
Honolulu
–10
Anchorage
–9
Los Angeles
–8
Denver
–7
Chicago
–6
New York
–5
Santiago
–4
–3
–2
Praia
–1
0
London
Paris
+1
Athens
+2
Jeddah
+3
Tehran
+3.5
Dubai
+4
Kabul
+4.5
Karachi
+5
Delhi
+5.5
Dhaka
+6
Yangon
+6.5
Bangkok
+7
Hong Kong
+8
Tokyo
+9
Adelaide
+9.5
Sydney
+10
Noumea
+11
Wellington
+12
4
Hide quick links:
Advertisement
